1 This specification is under the jurisdiction of ASTM Committee A01 on Steel, 2 For referenced ASTM standards, visit the ASTM website, , or. ASTM Aa(). Standard Specification for Tool Steel High Speed. standard by ASTM International, 03/01/ View all product details. Most Recent. ASTM A Standard Specification for High Speed Tool Steel.

Author: Arashiramar Mazutaxe
Country: Puerto Rico
Language: English (Spanish)
Genre: Video
Published (Last): 9 July 2015
Pages: 420
PDF File Size: 2.44 Mb
ePub File Size: 16.42 Mb
ISBN: 260-1-96595-641-6
Downloads: 73734
Price: Free* [*Free Regsitration Required]
Uploader: Fenriramar

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

Hardens by heat treatment and quenching. Then heat rapidly from F to F and hold for 3 to 5 minutes followed by quenching in oil, air or salt bath. Link to Active This link will always route to the current Active version of the standard.

Not applicable to this alloy. The M2 alloy has somewhat better wear resistance than M1. Primarily used for cutting tools.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The values given in parentheses are mathematical conversions to SI units that are provided for information only and satm not considered standard. Historical Version s – view previous versions of standard.

  BS 6349-2 PDF

Two intermediate high speed tool steels designated as M50 and M52 are also covered.

ASTM A600 T5 High Speed Tool Steel Round Bar

Formed by machining or forging and then machining. A chemical analysis of each heat of steel shall be made to determine the percentage astn the zstm specified including carbon, manganese, phosphorus, sulfur, silicon, chromium, vanadium, tungsten, molybdenum, and cobalt and these values shall conform to the requirements as to the prescribed chemical composition.

It may be shaped by grinding but is relatively poor in regard to capability of being ground. M2 is classified as a “medium” machinability tool steel in the annealed condition.

ASTM A – 92A() – Standard Specification for Tool Steel High Speed

This abstract is a brief summary of the referenced standard. Preheat at F before heating for hardening. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Distributors will offer small quantity buys while mills will generally only sell large quantities, with delivery times anywhere from 10 to 50 weeks depending on size and form required This material is stocked primarily in Bar Products by 28 distributors but is also available to a lesser extent in Flat Rolled Products, Wire Products, and Shapes.

  ASTRALNE VEZE PDF

See “Forging” and consult the supplier for information on working at lower temperatures. Unless otherwise specified, material shall be made by an electric melting process.

Grades and Trade Names

See “Heat Treatment” and “Tempering”. The maximum Brinell hardness and minimum Rockwell C hardness for the tool steels s600 given. Anneal at F and slow furnace cool at 40 F per hour, or less.

Cold working may be accomplished with the alloy in the annealed condition. Forge at F down to F. Temper at F for a hardness of Rockwell C w600 to Consult the alloy supplier for information on the advisability of welding. Modulus of Elasticity Tension. Selection will depend upon design, service conditions, and mechanical properties. Do Not forge below F.