GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.

Author: Nibar Tygokora
Country: South Sudan
Language: English (Spanish)
Genre: Career
Published (Last): 10 August 2016
Pages: 429
PDF File Size: 11.70 Mb
ePub File Size: 1.94 Mb
ISBN: 937-1-76699-679-6
Downloads: 68764
Price: Free* [*Free Regsitration Required]
Uploader: Malaran

Historical Version s – view previous versions of standard. Forward R4716 Manufacturers Co. Your email address is incorrect! I would like your verified suppliers matching service!

Please enter 20 to characters to contact this supplier! If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias. Site Member 3 Years.

Comparative tests as directed in 5. Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. Enter your email please.

Recommended Quality Verified Suppliers. Inquiry Sent Successfully Confirmation email has been sent: The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun.


Products – BT Technology

Combining values from the two systems may result in s4716 with the standard. Referenced Documents purchase separately The dd4716 listed below are referenced within the subject standard but are not provided as part of the standard. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.

ASTM D4716 Geosynthetic in-Plane Water Flow Rate Tester

Link to Active This link will always route to the current Active version of the standard. As a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.


Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.

Send your message to this supplier. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The flow d47716 water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces.

Your message must be betweencharacters!

Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or asym product. Please reply me widthin 24 hours.

Your message has been sent to the following suppliers. For the best results, we recommend including the following details: Please reply me within 24 hours. Competent statistical assistance is recommended for d476 investigation of bias.