KS datasheet, KS pdf, KS data sheet, datasheet, data sheet, pdf, Samsung 16COM / 40SEG DRIVER & CONTROLLER FOR DOT MATRIX LCD. Dot Matrix LCD Controller/Driver. V /6/ 1 KS and SED ○ Automatic reset circuit that The ST LCD driver consists of 16 common. Your LCD controller obviously has the correct power applied otherwise you would see smoke instead of blocks. Your backlight also appears to.

Author: Arashirisar Dairr
Country: Moldova, Republic of
Language: English (Spanish)
Genre: Finance
Published (Last): 25 March 2013
Pages: 340
PDF File Size: 8.34 Mb
ePub File Size: 5.87 Mb
ISBN: 551-8-42130-131-4
Downloads: 67180
Price: Free* [*Free Regsitration Required]
Uploader: Taura

The initialization routine is given on page 29 of this online manual: There are also controllers available that are compatible and provide additional features like an increased number of segment drivers for more characters or internal LCD contrast voltage generators e.

Problem: Arduino & LCD with KS / SPLC

Fixed memoryaddress confusion in address method. Debug breakpoints automatically disabled 16F88 cannot set internal oscillator frequency beyond I checked the other pins by using the “diode” test of my multimeter one Pin to the soldered Pin, the other to the board.

Please post your sample code if you don’t mind, that would be most appreciated. I followed their initialization routine, and I can get the cursor to blink and everything, but then Ocd wasn’t able to write any characters. By continuing to use our site, you consent to our cookies. The Hello World example. But the good news stops there, for me anyways I’m sure you’re ks006 than me because I’ve been trying to get the thing to work for the past 48 hours 14 of which was continuous, starting this morning and it doesn’t want to work.

  KENNETH KOBRE PDF

Access Warning You do not have the correct permissions to perform this operation.

HD44780 vs. KS0066

This is the code I used. I found the data sheet here: I already checked the soldering before I started programming the arduino.

Haven’t received registration validation E-mail? That’s pin 5 as shown bere: The new lib supports several ways of connecting with mbed:.

Any help with LCD driver KS0066/S6A0069?

There are also no bridges between pins: Pin 16 wasn’t soldered that good, so I wired it again. I still suspect a bad connection between the Arduino and the LCD so now it’s time to get out the magnifying glass and lc the solder connections on the LCD pins.

Try disconnecting both backlight wires and see if you can discern anything on the display when you run your sketch. I traced the problem and it turns out the ‘busy signal’ never goes low after initialization, which I could only think it means the initialization isn’t complete.

  JENSEITS VOM MITTELMA PDF

We are back to this “The reversed backlight connections that seem to work OK still bother me as well.

Accept and hide this message. What else can I try to fix this damn problem?

I already tried some othere libraries like the LCD4Bit but it didn’t wor either. User Control Panel Log out.

Last commit 06 Nov by Wim Huiskamp. Guest Super Member Total Posts: Essentials Only Full Version.

KS Datasheet pdf – 16COM / 40SEG DRIVER & CONTROLLER FOR DOT MATRIX LCD – Samsung Electronic

I’m still thinking about it. This site uses cookies to store information on your ckntroller. Important Information for this Arm website This site uses cookies to store information on your computer. Thank you very much.

Don’t wanna expend another 22 Bugs on a new LCd